PPH-3102-L1C(D) 100BASE-LX up to 125M 1310nm SMF 10Km SFP Optical Transceiver

Features
  Build-in PHY supporting SGMII Interface
  Build-in high performance MCU supporting easier configuration
  100BASE-LX operation
  1310nm FP laser and PIN photo-detector
  10km transmission with SMF
  Standard serial ID information Compatible with SFP MSA
  SFP MSA package with duplex LC connector
  With Spring-Latch for high density application
  Very low EMI and excellent ESD protection
  +3.3V single power supply
  Operating case temperature: 0 to +70°C

Applications
  Switch to Switch interface
  Switched backplane applications
  Router/Server interface
  Other optical transmission systems

Standard
  Compatible with SFP MSA
  Compatible with IEEE 802.3ah-2004

Description
The SFP transceiver is high performance, cost effective modules. It is designed for 100BASE-LX applications of 10km with SMF. The transceiver consists of two sections: The standard SFP part and the PHY part built with SGMII interface.
The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS(or Link)/Disable/Fault information via I2C register access. The standard serial ID information Compatible with SFP MSA describes the transceiver’s capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the 2-wire serial CMOS EEPROM protocol. For further information, please refer to SFP Multi-Source Agreement (MSA).